The sheets are used for manufacturing of various components used for the sealing of fixed joints; for reduction of abrasion loss of metal surfaces and for absorbing temporary loads. They also find application for use as gaskets, floorings and other sealing requirements.
Sheets are available as follows:-
I – rubber sheets
II – rubber-textile sheets
The following grades are available:
- high and low temperature resistant, oil-, acid-, alkali-resistant
- oil-, petrol-resistant
Grade |
Type |
Hardness |
Temperature, °C |
Operating media |
high and low temperature resistant, oil-, acid-, alkali-resistant |
I, II I, II I, II |
soft medium hard |
from –45 to +80 from –30 to +80 from –30 to +80 |
Ambient air room, tanks, vessels; nitrogen, inert gases with the pressure from 0,05 to 0,4 MPa or fresh, sea, industrial, waste water without organic solvents and lubricants, salt solution with concentration up to saturation point, acids, alkalis with concentration not more than 20% with the pressure from 0,05 to 10,0 MPa. |
oil-, petrol-resistant |
I I I |
soft medium hard |
from –30 to +80 from –30 to +80 from –30 to +80 |
Ambient air in rooms, tanks, vessels; inert gases with pressure from 0,05 to 0,4 MPa, or oils, oil-based fuels, petrol with pressure from 0,05 to 10,0 MPa. |
Dimensions:
- Curing via continuous vulcanization.
thickness – from 1 to 8 mm
width – to 1300 mm
length, m – in rolls
- Curing via ovens:
thickness – from 12 to 60 mm
sheet size – 1300 x 1600 mm